Durso construction
 

As it was going to be much to large I have decided to go with 1 1/2" PVC fittings and tubing. To make for even more space saved I have trimmed off part of the 90 and the T fittings to make it even more space efficient.


http://members.shaw.ca/montipora/DIY/durso1.jpg

[ 04 February 2002: Message edited by: DJ88 ]</p>

Durso construction
 

Here is the lower fitting that goes into the bulkhead in the bottom of the tank. As well the top cap which will have a small air valve mounted in it to conto the water level in the standpipe.

http://members.shaw.ca/montipora/DIY/durso2.jpg

Durso construction
 

All fittings "put together" and in the tank. So that woud lbe able to use the large tubing and such wiht a smaller overflow box I wanted, I have not glued the top "T" fiting to the standpipe. Hopefully this will allow me to remove the top section as necessary.
http://members.shaw.ca/montipora/DIY/durso3.jpg

Durso construction
 

Another shot of the final assembly.

This weekend I will be making the overflow box and will have it mounted by next week.

See ya then. [img]images/smiles/icon_wink.gif[/img]

http://members.shaw.ca/montipora/DIY/durso4.jpg

Durso construction
 

hmm looks Good Darren, is the diamiter of the pipe suposed to get smaller as it leaves the tank? that is the impression I have gotten from the designs on the web...

Steve

Durso construction
 

I am putting the reduction after the bulkhead. I have spoken with others who haven't tho and it works fine for them.

Durso construction
 

Darren, FWIW, I tried both and found the reduction technique quieter.

Durso construction
 

Why didn't you just use a Stockman overflow? You would have been able to use the larger pipe size without any problems.

Did you find some flexible PVC when you bought your fittings?

Durso construction
 

And make sure that you do a really good job of making sure that the male threads on the stand pipe and the female threads in the bulkhead remain clean. If you get even a couple of grains of sand in there you'll be hard pressed to ever get the stand pipe out.

Durso construction
 

Darren,

So what is the distance for the hole in the tank, from the edges? How big will the overflow box be?