![]() |
apex issue
im trying to set this apex up and its not working out.
the energy 8 bar isnt showing up in fusion its just the variable ports alarms and emails. the status light on the energy 8 bar is solid green and when i go on the head unit under modules it shows up E8-3 where do I go from here? also anyone local willing to set this up for me before I throw it in the dogs bowl gets beer or cash. I have zero patience for electronics |
1 Attachment(s)
If the module is listed then you just need to add the icons to you fusion page.
Press the unlock button a new grey box appears, drag them out of that to where you want them and lock it again. See image |
there are only 7 there and they are
base_var1 base_var2 base_var3 base_var4 base alarm base warning base email and everything shakes like an iphone when moving apps |
Do you already have anything programmed? Or is this initial setup?
Is it new? Or was it already run by someone else? |
You did scroll over in the unused tile box right?
|
If you were in Calgary I'd help ya but....
|
If you still can't file the tiles, log on to the device via the internal webpages (by IP address), and Initialize aquabus devices under Configuration -> Misc Setup
|
Might be easier to set it up in the web interface first, then I expect it would show in fusion. I set up fusion after the unit was already configured, so can't say for sure if this is normal or not.
If you type the IP into your browser, you should get the web page |
ok so I now have the tiles in the right spot and set them all up for what I want them to control.
changing the off /auto/ on on fusion doesnt power anything. its a brand new unit. |
Changing Off / On should switch whatever is plugged into that outlet.
They are 1-4 top row, 5-8 bottom row. Auto will do nothing unless you have added programming to the outlet. |
All times are GMT. The time now is 02:06 PM. |
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.