![]() |
Transfer sand bed?
Hey looking for some help and clarification
I have a 55 gallon mixed reef which will be transferred to my new 120 gallon with 55 gallon sump The current tank is 10 months old, so the sand is 10 months old I vacuum the sand, or at least 50% of the sand in a reg basis Can I just transfer it to the new tank? I have read a lot about Re-cycling etc and nitrate boosts etc. I am running high grade gfo in a reactor with zero phosphates and less than 5 nitrates all the time. Any help? |
I wouldn't. Or at least, not without washing it in tank water thoroughly. I did that once, my tank died :)
|
I'd keep the sand but put it all in a pail and stick in the garden hose & start stirring... When the overflowing water is clear, go ahead and dump it back in to your tank.
|
Quote:
|
It's best to start the new tank with new substrate. Even with meticulous regular cleaning you'll still get a big ammonia spike if you try to transfer the existing sand bed. I'd personally never reuse a sand bed, even after a thorough rinsing. I'd possible consider reusing a larger grain aragonite after a bleach soak to get rid of any remaining organic material that might cause an ammonia spike, and then a few days in fresh RO/DI but it's so much easier to start fresh and not have to worry about problems.
|
Again, not terrible advice, but I have done the rinse and re-use without any ammonia. If I lived somewhere I could easily buy new sand, I may have gone that route. If at all concerned, a good wash with fresh water should clean it up fine. Or get all new sand, it'll be shiny and, well, new :)
|
I re-used my sand,I just cleaned it very well until the water was clean, so all the debries are gone and put it back in the new tank without any issues..
|
Maybe it would help the OP to know for those that have reused a sand bed, did you immediately transfer livestock over after adding the sand, before adding the sand, waited a few days before adding livestock? and did you have LPS, SPS, mixed reef?
|
Quote:
|
Quote:
|
All times are GMT. The time now is 01:02 PM. |
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.