FS: 100G starphire w/ Cracked Bottom
 

54"L x 22"W x 20"H w/ 1/2" 3 sided starphire glass, 1.75" holes drilled in the back pane for 1" bulkhead returns. Bottom pane is cracked down the middle and I am not intuitive enough to take the tank apart and reseal it with a new pane. Other than the crack the tank is in good condition, couple scratches on the front & scuff on the corner of the right side but nothing major.

http://i1091.photobucket.com/albums/...s/DSC_4048.jpg

Someone come take this baby off my hands before my new tank arrives. Perfect for a good DIYer.

Bring one or two other people along to pick it up as it is on the 4th floor of a condo complex and I will be unable to help due to a recent knee injury.

$200

Is the stand included

I would say the stand is not included as he is having a new tank built to replace this one.


Sent from my iPhone using Tapatalk

Correct!

bump

$150. take it away. new tank comes this week.

bump

bump

$100. New tank is here soon and need this gone before then. My loss is your gain. Elevator to the ground level is close to my door. Come take this and make it your new DIY project.

Pmed got pics of the crack??

Bump for a great deal if repairable.
Is it a straight crack or diagonal. I would think with a straight crack you could put a straight strip of glass across it with a very generous silicone bead and have no problems. Would cover with a sand bed

you could do that if it didnt stem from the overflow holes..

That does make it tougher for sure. I can say though when I bought my tank used it had corner overflow that was beat up and needed some tlc. I cut it out a caulked a piece of glass over the existing hole and then just re drilled my own hole and built my new overflow the way I wanted.
Not trying to hijack to trying to help with the sale.

haha i know and i appreciate it but there is no way to save this one. the holes have cracks steming all around them and the glass is even starting to chip in this area.

Lol. Alright I give up then. Good deal just the same

http://i1091.photobucket.com/albums/...s/IMG_1589.jpg

http://i1091.photobucket.com/albums/...s/IMG_1590.jpg

$100 is a great deal. Wouldn't take much to replace the bottom panel.

I seen ur new tank it looks nice buddy. I would have brought it back with me but I didn't have the room in my vehicle for it.

Oh man am I excited for it! Still no word on when it will be here though :(
Appreciate the thought Rusty dog

If I had the room you'd have your new tank already. Lol.
I just built my new tank last night on my kitchen table. Now I'm just waiting on my stand

bump. at this point id be good for someone to take the tank for free..

stand back or you're going to get run over =)

im shocked it didnt go for a 100! lol

Do you still have the tank?

I do, yes.

Deleted long post. Resent pm. :)

doubt you even check canreef any more wayne, I am finally getting around to setting up this tank. I bought the glass to fix it right after i picked it up from you but then.. life happened.

up until today i was under the belief all glass in this tank was 1/2"

turns out the sides are all 1/2 and the bottom that cracked is 3/8"


wish i noticed sooner, or perhaps wish you noticed, not sure if t hats how you spec'ed it but perhaps whoever the builder of the tank was "accidentaly" grabbed the wrong piece of glass, Perhaps the 1/2 inch would have withstood you tightening t he bulkheads that close to each other.

Thanks again for the glass, although it has just sit as a paperweight in the garrage for a while perhaps i can get it sorted out soon.