Plumbing Newbie
 

I'm not sure where to start, I just got a 46gal. bow front bought form here I'm not sure how to go about putting the plumbing together -_-; should I go to home depot? any other pvc stores cheaper place to go? what to use to seal? not really sure what I need :neutral:

Not sure what you mean by 'what to use to seal'. Rona, Home Depot, Corix, Ocean and Bulk all sell cement.
Home depot/Rona are fine for small quantities of elbows/tees etc.
Bulkreef Supply online or Corix for schedule 80 unions, Gate Valves and True Union Ball Valves. Also Ocean Aquatics or J&L Aquatics for Gate Valves.
Also, Rona has schedule 40 pipe, Home Depot only has 200 which is thinner but stupidly the same price.
Most of these places sell Bulkheads.
Make sure you spend the extra money and use Sch80 Unions as they have a larger ID.

Thank you for these places recommended! I'll just try and wing it. XD I'm not sure how to use SCH80

Schedule 80 is no different from schedule 40 in terms of putting it together. It just has thicker walls from what I understand. You really don't need Schedule 80 for our low pressure systems.

My sch80 recommendation was specifically for the larger ID unions

The below link has some good info that might help

http://saltwater.aquaticcommunity.co...umbing-basics/

Oh man I'm preparing to make the jump from FW to SW with a 210g tank I bought and that site is saving me some stress in plumbing prep. Thanks

I found this site helpful when planning as it shows what you can buy
http://www.pvcfittingsdirect.com/_e/...chedule_40.htm

Does any know where to buy black silicone around burnaby or surrey area? i found silicone 2 black but it's not for aquariums

King Ed, J&L

Thanks! i just called up kings ed it seems like they will have it in stock by Friday :cry:

Plumbing noise problem
 

on my overflow box it's been having this splash noise it's really really loud. not sure but the splash is crazy.

http://www.canreef.com/vbulletin/att...1&d=1335935842

BUMMP help.

What does the plumbing look like on the inside of the overflow? Is is just draining through the bulkhead?

Might use an external Durso

http://www.nano-reef.com/gallery/data/500/extdurso.jpg

ohh no.. I have to take this apart?? could I just drill the top?

I'm not an expert by any means, but I would think just drilling the top of the elbow would cause a leak.

You could do a type of duriso standpipe with that set-up. The part with the air hole would have to be higher than the tank to prevent water from coming out of it



http://t2.gstatic.com/images?q=tbn:A...ukHtrZzMF2c9OA

Your going to want to replace that 90 with a T. Put a cap in the top of the T with an air hole drilled. I you want to get fancy you can run a piece of air line with a valve out of the air hole.

What your going to have to make is an external durso standpipe. If you google it you should be able to find diagrams.