Gauging Interset 2x3/4"SS (Edmonton, AB) *SOLD*
 

Hi,

Just seeing if anyone might be interested in 2x3/4" Sea Swirls. One is about 6 months old, the other is probably 1 1/2 years or so. I'm asking $160 shipped for the 6month old one and $135 shipped for the 1 1/2 years old one. Or take both for $275 shipped via UPS. Both work flawlessly.

They are available immediately.

Thanks for looking!

pm sent.

check your pm


mike

Anyone?

Check you pm again :mrgreen:


mike

PM sent.

i'd be interested in one.

Bump,

Buyer fell through?

^ Bump

A lot of pictures and measurements of the SS can be found here:
http://members.shaw.ca/harvwong/12.22.04/

how much area/clearance do you need for the sea swirl arm to turn, get what i mean?

Do you mean from side to side? If that is the case, you need as much room as a 3/4" elbow and a locline nozzle. Sorry, but I don't have an exact measurement with me at the moment.

http://members.shaw.ca/smokinreefer/ss.jpg

so it looks like you need 4 1/2" clearance for the arm of the sea swirl to rotate...

can that nozzle be disconnected at the 2 1/2" mark?

thanks.

Hi,

Yes, the elbow is just a normal slip x threaded elbow with a locline nozzle. You can disconnect the nozzle from the elbow.

Sorry, I forgot I had that picture!