Vertex rodi issue.
 

Changed filters last week turned on to make water and have low booster pressure and low water production.. So I then put in new membrane. Made sure multiple times that there was no trapped air. Still low pressure and minimal water produced

Any ideas?

I don't know much about the booster pump systems.
I'd be inclined to replace again one of the just replaced filters - maybe you got a faulty one.

Have you disconnected any hoses or electrical wires?
Just in case, I found this link, that you can compare to:
http://www.watergeneral.com/support/...struction2.pdf

Did such.. Even tried no filters

Sounds like the booster is fried , does it turn on can you feel it vibrate when it kicks in?

Booster kicks in.. Goes up to 60psi

Sounds like pump is done, both of mine run at ~125 psi.

Agreed 60psi is what you should get without the booster

Looks like I'll be ordering a pump

If you bought it new you may be able to get warranty?:)

I'll call proline and see

If not ask them for a used booster pump to buy they always have them in stock :)

Before you order new, check your connections.
Is the booster pump getting power?
Is the pressure sender sending the proper signal? If not, the pump will think that the psi is already high.
As mentioned take the pump off line and see if it will run, if it is getting power?
12V pump? maybe the transformer if pump does not start.
A lot of things to check before you have to spend big bucks

I can feel the pump vibrate,

Pump
 

Nick, I think I've a pump(used, but works) downstairs if you need one ASAP, feel free to use it until you get a replacement.
I've actually got a whole setup, so anything you might need, I should have.

Thanks Bob I'll keep u in mind.. Phil is going to bring get me his unit so I can get tank filled. I have MSG proline also