lol..

little off topic
 

sorry Colin for being a little off topic but Doug, I don't clean normal garbage.... the garbage that I clean are "special".

Arint forums great a conversation can go from hi tech controlers to Garbage HEHE

well now back to controlers

Ok I used some translation software to find out the lower BNC connector (the one that sticks out) on the Redox/Cond is for the conductivity just incase someone else is scratching there head on this one

i was wondering about that. thanks for the info buddy, i hadnt look into it yet because i have not hooked it up yet.now your next and most important task is to figure out how to get my WLAN to work. just kidding. i'm assuming that i am stuck figuring it out on my own because there is no response from anyone that supplies the unit

Have you tried emailing Jason at proline it might take a couple of days as it is the holiday season but he has responded to all my emails it is hard to diagnose WLAN problems with out being there

Hi guys
Sorry for the late response.We are closed till Jan 3rd &I was out of town for a few days.
Colin would you please explain how far you are with the w-lan set up & what seems to be the difficulty?
Doug ,how are you making out ,everything set up already?
Did you figure out the levelsensor holder?:mrgreen: :mrgreen: :mrgreen:

Need some help with your Profilux?
 

Just got a hint that you may need some help to setting up your Profilux Controller. I have it in operation with WLAN and other accessories and it works fine for me.

You can also visit my homepage (german language but you will get the picture anyway). Do not hesitate to contact me in case you have questions or visit also the www.aqua-it.de forum an place your questions in english there.

cheers
big blue

English Forum on www.aqua-it.de
 

Please be informed that we just opened a english speaking forum section to give you more Profilux support in your own language.

BTW: do not ask me to much about saltwater Aquariums, I am more on the freshwater-side. But swimming with sharks is quite thrilling (longimanus 2.5m in the red sea)

well i had the unit connected to the computer with the serial cable. i finally figured out how to setup my wireless network to accept computer to computer access in order to connect to the controller, i then followed the wlan/lan tutorial from the disc on all the steps, after that i setup the redirector. i assigned ip address and set the port to 10002. on the controller under communication i assigned the unit to use the router function, serial 2/WLAN and default to WLAN. when i disconnect the serial cable and try to then use the program to connect it cannot find the controller. i tried using a hyper terminal on computer and it does not locate the unit. i truly have no idea where to start from here.i hope this is enough info