Have you seen this
http://www.neptunesystems.com/wp-con...14/05/afqs.pdf

Did you run the utility to find the ip of the controller on your network? You type in that ip in your browser to get access to you controller with you Mac (this was the regular way before fusion). You have to either enable fusion by going into the controller with the old method and get the token (I think it was a 4 or 5 digit code).

Then in fusion you go to link and type in that token code.

Then you should be set.

Yes thats site I used. I cant get it to recognize the controller IP. I will try again.
Thanks so much for the help.

Thanks Pat for all the help and to the others that have contributed. I now have it running on both computers and my iPhone.

Just need to figure out all the probes/outlets and such that Im not using. But at least its loaded and I can control from my phone.

So after switching tanks and reconnecting my Apex, it worked fine. Then yesterday I click on it and wont load. Same today. Tried switching ports.
Any ideas.
Thanks

Nevermind. I figured it out and have it working again. Still cant find my tile to link Fusion again however....:lol:


HA. Fixed it to.