Back to the thread i guess

Just finished debugging the fan breeze instructions into English if anyone wants a copy

Regards
Michael

No Prolem Colin
We are all in this together:lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :lol: :drinking: :drinking:
I am pulling for you.
(Reminds me of RED Green show)

Too temping to respond to line about the 18 year old :surprise: ..... but I won't.

Can I control any fan that uses an AC/DC adapter with Propeller Breeze Control module?

And must I buy the LED's made by ProfiLux or can I use any dimmable LED light?

How to display a graph
 

I have been attempting to display a graph of my parameters and all I can seem to get after I 'read and save data' and then 'display graphics' is ......

a graph where all the data is drawn on the left most vertical axis. It is not drawn across the page in alignment with the predetermined time stamps. The graphs are complete with times, parameter names, and units. But the red line that appears to represent the actual measurement data is not readable in terms of units vs. time. It's just a red line that keeps drawing over itself on the 'zero time' axis.

Anyone have any luck with this. I tried exporting the data to excel and build a graph over there. But it became so cumbersome and illegible that I finally gave up. Should I be able to see a graph with out having to build one in excel? If so...how do I get it to display properly.

Hi

As far as I know you can only use the profilux fan via the controller, this is due to potential overload.

The GHL LED's are designed to plug straight into the back of the profiLux via western connections, as GHL are the only holders of the wiring of the plugs it would be unwise to plug third partyy equipment into the back of the profilux, however there are third party adapters for the control of 1-10V supply lines for imming lights

If you let me know what you wish to achieve I can guide you better

Regards
Michael

Michael

can you confirm this above so i can gear up to get the right bits
also any simple quides to follow to achive this

thanks
himat

Sounds fine to me

Regards
michael

splitters
 

Michael

any info about the splitters

thanks
himat

WLAN setup
 

I am still waiting for the new firmware and software to set up my ProfiLux Plus II controller with the WLAN.
Hope it come up with the easiest procedure for that.

Please let me know if that posible this weekend.

Thanks

Lam