Canreef Aquatics Bulletin Board - Daplatapus's 77 Gal

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)

- Tank Journal (http://www.canreef.com/vbulletin/forumdisplay.php?f=18)

- - Daplatapus's 77 Gal (http://www.canreef.com/vbulletin/showthread.php?t=86599)

Bum Bum Bum

Rainy today and don't feel like working outside :)

Today is D-Day for switching this:
http://i1177.photobucket.com/albums/...s/PB172259.jpg

That is a really old pic of the sump, several mods were done to it including a water change system, Calcium reactor, etc etc etc.

This is the new sump

http://i1177.photobucket.com/albums/...s/newsump4.jpg

Wish me luck....

The new Sump looks Slick!

Quote:

Originally Posted by daplatapus (Post 755162)

I've certainly noticed growth rates pick up since adding my calcium reactor a month or 2 ago. Way steadier Ca and dkh levels. Anyway, let me know what ya think...

Glad to know the CA reactor setup works out well.

Quote:

Originally Posted by freezetyle (Post 756342)

The new Sump looks Slick!

Thanks Jon. It's Brad's old sump brought back to life again with a couple baffle reconfigurations :)

Quote:

Originally Posted by apexifd (Post 756385)

Glad to know the CA reactor setup works out well.

Ya, once I figured out that first 1/4" line I tried using wasn't seating in the JG fitting and switched it out for new stuff, all's been good. I really like it.

Well it is semi-finished. I still have some shelving to re-build to put the Ca reactor and the Mg dosing equipment and clean up some stray wires and hoses, but it's up and running. I also have to still plumb in the drain to the floor drain for my water changes but that's just a couple elbows to re-tie that back in where it used to be.
The new filter sock configuration is AWESOME! And for some reason even my main herbie drain from the 77 gal catches siphon faster than it used to, not sure why.
I replaced my glass heaters with a couple 300W Titanium heaters and put them in the upflow from the filter socks to the skimmer section.
The one section that has the pile of rock in it is going to house my algae turf scrubber and the rock will end up in the 210 when I get it set up. Still researching those upflow ATS so it may be a bit for that.
I've drilled the bottom of the return chamber and the pump is fed from under the tank.
Any thoughts to the new setup? Do any of you see anything I might have missed that will cause me headaches in the future?

http://i1177.photobucket.com/albums/...s/IMAG0394.jpg

http://i1177.photobucket.com/albums/...s/IMAG0392.jpg

http://i1177.photobucket.com/albums/...s/IMAG0391.jpg

you can use neomag or zeomag as magnesium media in the reactor, 10% of the total media used in the reactor. or just fill the second chamber with it.

than you don't have to dose magnesium.

GAH! I have flat worms. I don't see them at all in my main DT but there's got to be a couple hundred all of a sudden in my cube (which is all tied together through a common sump).
For some reason I was expecting something much larger. But I can see a bunch on my front glass and maybe some on the base frag plugs of a couple sps.
Arghh... I knew things were going too well....