Canreef Aquatics Bulletin Board

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)
-   Tank Journal (http://www.canreef.com/vbulletin/forumdisplay.php?f=18)
-   -   New build 118gallon (http://www.canreef.com/vbulletin/showthread.php?t=124236)

Mattyb 10-17-2017 04:15 AM

Quote:

Originally Posted by Mattyb (Post 1019512)



So my floor has to be the worst,my tank was level before putting water in it. Now my level is slightly off. Should I have anything to worry about? It

JamRobo 10-17-2017 04:18 AM

Yikes thats a bit sketchy, can u measure floor to cieling below the tank and make sure its not sagging?

Sent from my SM-G930W8 using Tapatalk

Mattyb 10-18-2017 02:27 AM

Quote:

Originally Posted by JamRobo (Post 1019538)
Yikes thats a bit sketchy, can u measure floor to cieling below the tank and make sure its not sagging?

Sent from my SM-G930W8 using Tapatalk



So managed to get the tank level. Fill the tank last night and put new sand in. Saved a small amount from my other and added that in also. Today I managed to get my rock put back in. And now climatizing my coral. Hopefully I won

Mattyb 10-18-2017 02:29 AM

Oops, hopefully I won’t loose any coral.

Mattyb 10-18-2017 02:30 AM

Quote:

Originally Posted by Mattyb (Post 1019580)
Oops, hopefully I won’t loose any coral.



https://uploads.tapatalk-cdn.com/201...bb1785fc80.jpg



Sent from my iPhone using Tapatalk

JamRobo 10-18-2017 02:46 AM

Nice! Looks good! Ya fingers crossed it doesent go through to much a cycle. It shouldn't considering all the rock and bit of sand.

Mattyb 10-18-2017 02:57 AM

Still need to figure out the lights. Rather not hang them from the ceiling. The bars on the end here don’t seem to stable. Might have a metal
Fabricator create some new ones that can hang the same way.

JamRobo 10-18-2017 04:23 AM

Sweet ya would look nicer forsure getting some fabricated. If you do end up going the hanging route i just made my light mount and hanging system.

I used some angle racking material from home depot.
http://m.homehardware.ca/h5/m/en/r/h...tt=72%22+steel

and just bolted it all together and painted it.
Ive found some perfect ratchet pullys on amazon that are cheap and make it easy to raise and lower the light fixture.
https://www.amazon.ca/gp/aw/d/B01I54...?ie=UTF8&psc=1

Its heavy duty but mine is also holding up 2c 8 bulb tek lights and 2 radion xr30s hahah.




Sent from my SM-G930W8 using Tapatalk


All times are GMT. The time now is 10:04 AM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.