Yea it should work. This one would be your closest match: http://www.modularled.ca/inventronics-700ma-96w-driver/

inventronics-700ma-96w-driver good for 24 to 44 LEDs at 3W each. But mine is 25 0f 6W each?

I could try and help you out, do you have any information on the type, model number or maybe where you bought your 6w LEDs

Yes the LEDs are capeable of 6W each but that would be running them at full capacity most-likely 1A or 1.5A.

That 96w driver is comparable to the specs you quoted. Perhaps are there two drivers inside the fixture?

Sorry it was in other post. There are two drivers. Total 300W. 25 blues at 6W each on one driver and 25 whites at 6W each on the other.

Bought it at Aquatopusa. It is a LED light fixture.

Here is the link for a fixture i bought:

http://www.aquatopled.com/mm5/mercha...t_Code=AQ300W0

Hi Martin,

Can I go with 2 of these:

http://www.modularled.ca/inventronic...a-120w-driver/

From doing a quick reading (aquatopled, Bridgelux and Epistar)
your array is running at 50% of its capacity I wouldn't suggest running it hygher as I am not to sure about Bridgelux and Epistar LEDs.
So to say your leds are rated at 6w but in actual running at 600 to 700ma
That said I think what Martin is offering is good for your array.

Ya I just want to make sure 96W is enough or should I get the 120W