Omg... I found my problem.... This is what I purchased.... http://m.thesource.ca/product.php?pt...675&lang=en-CA

It's an 24v ac adapter. Were can I find dc adapter?

actually you would only one 1 amp diode to build a half wave rectifier but it might be better to build a bridge rectifier with 4 diodes

If is on the RO side move it on the other side, in front of the RO unit. You don't want to contaminate your RO water with metal ions. I don't like the idea of using a RO unit directly in a ATO system. When you start the RO unit the first 1-2 liters are not the best quality, if it produces only 50ml or less 20-50 times a day, you're not gonna get the best water.

Thanks cal. I will do some research to find out how to build that.

I sure will move the valve over to the incoming water side. Thanks for the advice. I just hope I didn't damage anything by letting it run with ac for a good 30 min already...

no, should not have damaged it, just google "bridge rectifier", the diodes will get warm so if you tape them up do it so the plastic part of the diode is exposed to the air so they doesn't overheat

Cal does this look right?

no, you have the red and black reversed, the polarity is wrong, however, the solenoid might not care about polarity but I would correct it just in case

You're much better off finding a 24 VDC adapter. All the components will be designed to the specifications the adapter is made for. Trying to piece together a full wave rectifier with loose components without knowing the specs of the adapter you're using is looking for trouble. There's generally more to a rectifier than a few diodes. Many rectifier circuits include resistors, capacitors & coils to further filter the AC signal.

Might have to look a little harder for a 24 VDC adapter but they are available. Example, the EcoTech VorTech power supplies are 24 VDC. Costly option, but I'm sure if you search around on the net, you'll find something suitable for a reasonable price.

[quote=mike31154;678937]You're much better off finding a 24 VDC adapter. All the components will be designed to the specifications the adapter is made for. Trying to piece together a full wave rectifier with loose components without knowing the specs of the adapter you're using is looking for trouble. There's generally more to a rectifier than a few diodes. Many rectifier circuits include resistors, capacitors & coils to further filter the AC signal.

The transformer he is using is rated at 1 amp, the diodes are rated at 1 amp, the coil he is powering probably draws about 1/4 amp, he has soldered his connections, other than the reverse polarity he has done a fine job.

For noise check for loose screws on the top of the unit, I have a similar one and it made a loud buzzing sound when one of the screws holding the solenoid on came loose.

Verify that the voltage is in fact 24VDC, not very typical. 24VAC is standard for sprinkler solenoid, which you can also use, rainbirds have been very reliable IME.

If you're using this for top off directly from an RO unit be sure you have enough safety built in to it so it won't be accidently left on too long or stay on from a faulty float switch or even the solenoid.