Canreef Aquatics Bulletin Board

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)
-   Polls (http://www.canreef.com/vbulletin/forumdisplay.php?f=34)
-   -   SAND OR NO SAND (http://www.canreef.com/vbulletin/showthread.php?t=79005)

Aquattro 10-07-2011 10:07 PM

Quote:

Originally Posted by lastlight (Post 641353)
Yes I've experienced this myself. One reason I put my filter socks back on.

Same here. Floating particulate would reduce PE on my acros.

Reefie 10-07-2011 10:09 PM

IMO, you can never have too much flow! Blowing sand is just a matter of aiming the PH up a little higher so the flow doesn't disturb the sand. The particulates are what our filter feeders consume. Less flow and problems like GHA or cyano arise.

BBlinks, I believe your new 300G is also 27" tall right?

Bblinks 10-07-2011 10:30 PM

Quote:

Originally Posted by Reefie (Post 641358)
IMO, you can never have too much flow! Blowing sand is just a matter of aiming the PH up a little higher so the flow doesn't disturb the sand. The particulates are what our filter feeders consume. Less flow and problems like GHA or cyano arise.

BBlinks, I believe your new 300G is also 27" tall right?

It will be 27 tall, but even with the 210 sitting at 29 I still see a lot of stuff floating around even with filter sock in place.

btw I didnt like your comment in my pm box. A$$HOLE.:mrgreen:

s.tan 10-08-2011 06:38 PM

Quote:

Originally Posted by globaldesigns (Post 641344)
I also don't personally like the look of a bare bottom.

Depends on whose it is...:mrgreen: LOL! Sorry, couldn't resist!

amoreira 10-08-2011 07:30 PM

I keep a 6-8" DSB. Haven't touched it in 2 years. Corals are healthy. No problem with nuisance algae. Water parameters are 0 phosphates, 0 nitrates. DSB is a good option IMO.

Bblinks 10-08-2011 09:19 PM

Quote:

Originally Posted by amoreira (Post 641493)
I keep a 6-8" DSB. Haven't touched it in 2 years. Corals are healthy. No problem with nuisance algae. Water parameters are 0 phosphates, 0 nitrates. DSB is a good option IMO.

What kind of corals do you keep in your tank?

abcha0s 10-09-2011 07:28 PM

Quote:

Originally Posted by Bblinks (Post 641295)
That's the predicament I am faced with. I got 4x6105 and a wavebox. Some times when the pump gets bumped by a fish and it will start a sand storm. I think I am gonna go with a bare-bottom for starters and if I don;'t like the look of it I'll just add a bit of sand.

I had a problem with my 6205 PHs where they would slip and point downward into the sand bed. It drove me crazy. I complained to Tunze and they suggested squeezing the C clamps to tighten the grip. I did this but was worried about breaking them if I squeezed too hard. After my first attempt, there was little improvement. I then asked Tunze again what I should do and they said squeeze harder - if they break, we will replace them. So, I squeezed to the point where I felt the C tighten. They did not break and they have never slipped since. Perhaps not an elegant solution, but it solved my problem.

I vote for having a sand bed. Get some sand sifting gobies to keep it clean. My sand bed is always white. I opted for a 1" sand bed in my bigger tank and it works well. I might increase the depth to 1.5" one day, but for now it's fine.

I like the DSBs too, but they do require more thought and need to be properly seeded with micro and macro fauna.

- Brad

Bblinks 10-10-2011 02:49 AM

Hi Brad.

It's always good to get your input. I think you are right about having a inch of sand just so it will make maintenance much less time consuming, and of course make the tank look more natural. The commander(wife) also agrees with the a thin layer of sand. So inch of sand it is.
Thanks everyone who voted and taken the time to reply to the thread.
Rich
Quote:

Originally Posted by abcha0s@conceptaquatics (Post 641687)
I had a problem with my 6205 PHs where they would slip and point downward into the sand bed. It drove me crazy. I complained to Tunze and they suggested squeezing the C clamps to tighten the grip. I did this but was worried about breaking them if I squeezed too hard. After my first attempt, there was little improvement. I then asked Tunze again what I should do and they said squeeze harder - if they break, we will replace them. So, I squeezed to the point where I felt the C tighten. They did not break and they have never slipped since. Perhaps not an elegant solution, but it solved my problem.

I vote for having a sand bed. Get some sand sifting gobies to keep it clean. My sand bed is always white. I opted for a 1" sand bed in my bigger tank and it works well. I might increase the depth to 1.5" one day, but for now it's fine.

I like the DSBs too, but they do require more thought and need to be properly seeded with micro and macro fauna.

- Brad



All times are GMT. The time now is 12:34 PM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.