Canreef Aquatics Bulletin Board - Seio 620

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)

- Reef (http://www.canreef.com/vbulletin/forumdisplay.php?f=8)

- - Seio 620 - Update/problem (http://www.canreef.com/vbulletin/showthread.php?t=15282)

look for the receipt.

Quote:

Originally Posted by Willow

look for the receipt.

willow, you'd make a terrible therapist. :lol:
But you're right none the less! heh

Quote:

Originally Posted by whaase

Thanks, for all the replys. Makes sense now, but, my seio seemed to have died. I had it running for 3 days, I had to shut it off for a couple minuts. When I turned it back on, nothing happened. I took it out, cleaned it (how ditrty could it be?). When I plug it in, I hear it humming, I took it apart again, this time I very loosely screwed the outer ring back on and plugged it back in. I have to smack it then it started. I let it run in fresh water over night, unplugged it, plugged it back in and it won't start again.... anyone have any ideas?

Walter

Try the opposite, when you screw back on the outer ring, tighten it so it can't no more. If it's not tight the shaft on the impeller isn't held down properly and that creates "play" and it wont' start. I had a similar problem, but not anymore.

have you been turning it on and off a lot?

Quote:

Originally Posted by Willow

have you been turning it on and off a lot?

No, I shut it off once and I had the problem. I did notice that there is a rubber bushing on the end cap, it seems a little tight in there... I'll play a bit more before I give up :biggrin:

I'll try tightening as suggested, thanks.

Walter

Just a update, it's working good now.

Walter