Canreef Aquatics Bulletin Board

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)
-   Reef (http://www.canreef.com/vbulletin/forumdisplay.php?f=8)
-   -   pH dropping -hello winter (http://www.canreef.com/vbulletin/showthread.php?t=102098)

Aquattro 11-05-2013 09:54 PM

Quote:

Originally Posted by Madreefer (Post 856796)
Bahhhh ph is over rated and for fear mongers. Don't fiddle. In a calcium reactor that's a different story

I don't even play with it in my reactor :)

eli@fijireefrock.com 11-05-2013 09:57 PM

I agree with most replies PH...what is that :biggrin: been a long and I mean a long time since I dipped in for PH...

xenon 11-05-2013 10:14 PM

Hook up a CO2 scrubber to your skimmer air intake and voila! problem solved.

It would be nice if we had scientific results on what a raised PH would do for our corals but we just don't know.

asylumdown 11-05-2013 10:23 PM

According to my Apex, the pH in my tank hovers between 2.4 and 2.8. Apparently the absence of a probe is quite acidic...

The one thing I would mention about reef buffer is to be careful about how you interpret your alkalinity readings after you use it. Reef buffer contains a significant amount of borate, which contributes to total alkalinity. If your'e using a single reagent titration test kit for carbonate (i.e., you add a single coloured reagent directly to your water until there is a colour change) to measure your dKH, you're measuring total alkalinity.

I ran in to a problem when I was a newb where I was adding too much reef buffer and not enough carbonate/bicarbonate. My dKH was consistently reading in the 8-9 range, but then all the tips of my corals started burning, then whole colonies started practically self immolating. I bought the Seachem test kit that allows you to test for both borate and total alkalinity and discovered that my carbonate alkalinity as measured in dKH was down around 4.5 or something ridiculous.

banditpowdercoat 11-05-2013 10:26 PM

Ya Mine has always been just below 8. Now last couple months its creeped to just above 8. No one seems to notice but me

Reef Pilot 11-05-2013 10:34 PM

Quote:

Originally Posted by asylumdown (Post 856820)
According to my Apex, the pH in my tank hovers between 2.4 and 2.8. Apparently the absence of a probe is quite acidic...

The one thing I would mention about reef buffer is to be careful about how you interpret your alkalinity readings after you use it. Reef buffer contains a significant amount of borate, which contributes to total alkalinity. If your'e using a single reagent titration test kit for carbonate (i.e., you add a single coloured reagent directly to your water until there is a colour change) to measure your dKH, you're measuring total alkalinity.

I ran in to a problem when I was a newb where I was adding too much reef buffer and not enough carbonate/bicarbonate. My dKH was consistently reading in the 8-9 range, but then all the tips of my corals started burning, then whole colonies started practically self immolating. I bought the Seachem test kit that allows you to test for both borate and total alkalinity and discovered that my carbonate alkalinity as measured in dKH was down around 4.5 or something ridiculous.

Hmmm, really?? I dose Seachem Reef Buffer (and have for a couple years) and keep my dKH around 8 or 9 (API, which is a single reagent test). I have in the past also tested with Elos or Salifert (can't remember which one), but the results were basically the same (just a finer granularity), so I went back to the API.

I have a lot of SPS in my tank and so far no problems. But now you have me worried. I may have to go out and buy another KH test kit. Is Seachem the one you recommend?

And I also have not tested pH for a year or more.

asylumdown 11-05-2013 10:48 PM

Quote:

Originally Posted by Reef Pilot (Post 856827)
Hmmm, really?? I dose Seachem Reef Buffer (and have for a couple years) and keep my dKH around 8 or 9 (API, which is a single reagent test). I have in the past also tested with Elos or Salifert (can't remember which one), but the results were basically the same (just a finer granularity), so I went back to the API.

I have a lot of SPS in my tank and so far no problems. But now you have me worried. I may have to go out and buy another KH test kit. Is Seachem the one you recommend?

And I also have not tested pH for a year or more.

It's their Reef Status Magnesium test kit, comes in an obnoxiously large white plastic case with a red label. In addition to mag, that test kit does total alk and borate alk. You subtract borate alk from total alk to get your carbonate alk.

It's the only test kit that I've seen that has reagents to test for borate alk, all the other kits you just mentioned test for total alk only, so it's good that they agree. I'm just guessing, but I bet they make it specifically because of their reef buffer product.

Keep in mind that this was in... 2008 I think, so it's possible that reef buffer's formula has been changed and the ratio of borate to carbonate is different now. I was also a serious idiot back then and had no idea what I was doing, as referenced by the fact that I managed to get in to a situation where it was that out of whack. That was the same year I destroyed all of my pumps in a runaway precipitation reaction because I didn't know the first thing about reef chemistry. Looking back at pictures of that tank makes me cringe now.

I'd just be aware of it. Obviously if you've been doing what you're doing for that long things are working, but I'd still want to know how that total alk number broke down.

asylumdown 11-05-2013 10:55 PM

hmmmm, i might be out to lunch, API might test for carbonate alkalinity directly. I haven't used it in years, what colour is the reagent when it comes out of the bottle?

Reef Pilot 11-05-2013 11:00 PM

Quote:

Originally Posted by asylumdown (Post 856833)
hmmmm, i might be out to lunch, API might test for carbonate alkalinity directly. I haven't used it in years, what colour is the reagent when it comes out of the bottle?

It is pink first, and then turns purple/blue.

asylumdown 11-05-2013 11:23 PM

hmmm, then nope it's still measuring total alk, even though the box says it's measuring KH, which is not the same thing and is usually expressed in different units (meq/L). I can't figure out what indicator they're using, but what's in your bottle is basically just an acid and an indicator that changes colour once all the buffering capacity has been consumed and the solution suddenly turns acidic. Might be litmus.

I just searched reef central and found some posts from Randy Holmes where he found that the borate alkalinity test from sachem wasn't all that accurate so he recommends not doing it. If you've been doing what you're doing for two years I'd say you're probably fine. My case was likely an extra special case of being 'extra special'.


All times are GMT. The time now is 10:17 AM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.