that wouldn't be to hard. pretty much just a standerd 10G with a few extra inches? should be about $60 for the glass i think.

http://i324.photobucket.com/albums/k...DSC_0053-4.jpg new monti with some cool purple and green nems of some sort

http://i324.photobucket.com/albums/k...DSC_0073-1.jpg and a close up fts

had a bit of birthday money kickin around and wanted to up my turn over a bit

so from 300 to 600 gph

http://i324.photobucket.com/albums/k...DSC_0001-1.jpg

ceramic bearings
http://i324.photobucket.com/albums/k...f/DSC_0003.jpg

new plumbing.
http://i324.photobucket.com/albums/k...DSC_0004-1.jpg

Closed loop or return?

return

How do you like the Tunze pump? Was thinking about getting one myself for a return pump. How silent is it?

^+1...

I was looking at this pump but I've decided to go to a Mag 7 for more turnover...

Ya...+2.... please tell how quiet is das Tunze.:mrgreen:

das tunze is a just a bit louder then the old ehiem 1250 i was running...

not to impressed so far actualy.. i did a water change this morning i went to plugthe pump back in and ....... nothing... not even a hum sound like the impeller is jamed... lots of bad language and a bit of fiddling... as in taking the return apart and pulling the pump out then putting it back in it started working again... so a few mins later i tryed it again and same thing happend.. ssooo its going back on the weekend and seeing if a replacment will change anything.


anyone think it could be like a MH bulb and has to cool down a bit first to fire back up.. because it will only start when i remove it from the water and put it back in...????

My Hydor pump is exactly like that. The impeller spins but it won't push water unless it sucks air first. Doesn't seem to be a heat/cooling issue .. I'm not sure why it's like that.