![]() |
Quote:
Aquaforest also recommends use of such products like 15mm Siporax, which when used in a reactor with slow flow, you will create an anaerobic zone for your tank (like a controlled DSB). Some people use SeaChem Matrix, but lab tests by RC member "reefvet" concluded that Siporax was much more efficient. It's the same idea as MarinePure and Matrix, but apparently this Siporax stuff is easier to keep clean and more efficient at denitrification, and also provide a medium for PO4/NO3 reducing bacteria. I'm going to put mine into a PhosBan reactor. For anyone looking, I was not able to find Siporax available anywhere in Canada. I found the cheapest (with shipping) overseas supply was eBay seller wttomy1 from Austria. I ordered 2L, and it was €6.90 per 1L Siporax, and about €20.00 for shipping. It worked out to CAD$52.41 on my CC in mid-October. http://www.ebay.ca/itm/Sera-08472-Si...R9yZBPEIUA76rQ This is supposedly the most efficient way to use them (all lined up in a reactor). http://i300.photobucket.com/albums/n...1D996515_1.jpg Some people just dump them into a container in the sump. http://i1268.photobucket.com/albums/...2/IMG_2312.jpg A closeup. http://www.indohobby.com/media/catal...tructure_1.jpg |
I did this same thing with hydroton, grew lots of fauna inside
|
Received my bucket of Aquaforest reef salt today. Should be receiving the rest of the products in the next week or two as well as Siporax.
Did a small 5 gallon water change to test parameters and overall I was impressed. It mixed clean and clear in a matter of minutes and all parameters were very close to the ones on the quality control sheet. Overall seems like a high quality salt and perfect for carbon dosing. Obviously to early to tell if it will have positive effects on my tank. Parameters at 1.026 salinity all tested with Salifert Calcium 415 Magnesium 1320 Alk 7.4dkh Potassium 400 A picture of the quality control test results is posted below. http://i1150.photobucket.com/albums/...2020.45.37.jpg http://i1150.photobucket.com/albums/...105_192455.jpg http://i1150.photobucket.com/albums/...105_192515.jpg http://i1150.photobucket.com/albums/...105_193235.jpg |
I recently purchased a bucket of their reef salt. I wanted to see where cal/alk/mag would be after mixing it.
We currently use Tropic Marin Pro Reef in-store because its low in alkalinity. All other salt brands we offer are high in alk and my SPS don't like it. What readings are you guys getting for the big 3 after mixing it up? Also, I run 3L of Siporax in a Vertex zeo reactor. Its only been a little over a month since I put it online so it might take a while to seed bacteria to get real results. |
Quote:
|
Quote:
If so, this will be the salt we use in-store from now on. |
I picked up my order of their reef salt from the post office last night. I'm looking forward to giving it a try. My tank doesn't have high requirements yet but I did like the value. Instant Ocean is more expensive at the LFS than this stuff was shipped through Amazon.
|
Am I the only one who bought the probiotic salt :cry:
|
Quote:
|
And by the way pro bio s smells way worse then zeo bak. The box must of had some on it and my entire garage smells with it sitting In the garbage. Smells like a waste treatment plant rather then a salt mixing station.
It's a good thing they state that it's not for human consumption on the box because it smells real appetizing... |
All times are GMT. The time now is 11:10 AM. |
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.