Conversation Between Jason McK and Tom R
Showing Visitor Messages 1 to 4 of 4
-
02-17-2013 11:55 PM
Tom R
Hi Jason
I may be interested in your 90G sump. I am not sure if I could retro fit it into my system.
I have a concern about my ABS water reservoir leaching into my water supply. Do you know if ABS is safe for Reef Systems.
Tom R
-
10-20-2012 10:20 PM
Tom R
Hi Jason
Its been a while. How is your tank doing. I have noticed that your back on CanReef lately and that you are looking to setup 180G. I am interested in your assessment of the 2 AI sol lights that you are using on the 120G. I would like to come over and have a look at the tank with the sol's in use some time.
I look forward to hearing from you.
Tom R
-
10-23-2010 03:48 PM
Tom R
Hi J
I was thinking of coming over.
Is there any time this weekend that works for you?
Tom R
-
12-17-2009 04:06 PM
Tom R
Hi Jason
After the discussion of your OM water banging problem last night, I was reading a thread today and they referred to using this lubricant on their OM. I was wondering if you have tried lubricating the inside drum.
I also wanted to apply a lubricant on the path travelled by the revolving door with some Dow Corning 111 o-ring lubricant (the same stuff that Ocean's Motions uses on the drums inside of their valves). Hopefully, that will create less friction on the door, as I believe it was barely binding on the inside of the housing. The lubricant is approved for use with food products and is reef safe.
I recently had a problem with one of my shower faucets and Kohler sent me a lubricant jell to lubricate the O rings as a way to stop it from dripping. I have a little bit of it left if you want to try it.
Tom R